Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mitsubishi Starion ESI-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Clutch Cover Bolt | 11-15 (15-21) |
| Flywheel-to-Crankshaft Bolts | 94-101 (128-137) |
| Hydraulic Flex Hose-to-Release Cylinder | 19-21 (26-29) |
| Hydraulic Line (Steel)-to-Master Cylinder | 10-12 (13-16) |
| Transmission-to-Engine Flange Bolt | 32-39 (43-53) |
| Starter Mount Bolt | 16-23 (22-31) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
