Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mitsubishi Starion ESI-RFACTORY OEM SERVICE PROCEDURE
ISC Servo
- Connect voltmeter between terminal No. 3 and injection mixer body. Do not disconnect ISC servo connector. Turn ignition switch from the "OFF" position to the "ON" position. While keeping ignition on for at least 15 seconds, check voltmeter reading.
- With ignition switch on, voltmeter should read 11-13 volts. After momentary indication of one volt, needle should stabilize at 6-13 volts. This indicates ISC servo and position switch are operating normally. Turn ignition switch to "OFF" to remove voltmeter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.