Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mitsubishi Starion ESI-RFACTORY OEM SERVICE PROCEDURE
Accelerator Cable
- For turbocharged vehicles, keep ignition key at "ON" position for at least 15 seconds before adjustment. Confirm that accelerator inner cable has no slackness.
- If cable shows slackness adjust as follows: loosen nut so that throttle lever is free. Check routing of accelerator cable to confirm that there are no sharp twists or bends. Use adjusting nut to make adjustment of free play to within specifications. On turbocharged vehicles, check that idle speed control switch touches the stopper after idle speed control adjustment.
ACCELERATOR CABLE FREE PLAY
| Application | In. (mm) |
|---|---|
| Free Play (at Pedal) | 0-.04 (0-1) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.