1985 Mitsubishi Montero BaseFACTORY OEM SERVICE PROCEDURE

Air Injection System - CALIF: Operation

The reed valve is actuated by exhaust vacuum being generated from pulsation in the exhaust manifold. Extra air is supplied into the exhaust manifold through secondary air control valve. The secondary air control valve is opened by the intake manifold pressure when the solenoid valve is energized by the ECU based on the information on coolant temperature, engine speed and idle position.

Fig 1: Pulse Air Injection System (Turbocharged Models)
G40007
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.