1985 Mitsubishi GalantFACTORY OEM SERVICE PROCEDURE

System Testing

  1. Cold start the engine and run at idle until normal operating temperature is attained.
  2. Remove the hose (Green stripe) from the injection mixer. Connect vacuum pump to hose end.
  3. Disconnect the solenoid valve connector and apply 3.9 in. Hg of vacuum. If idle becomes unstable or the engine stalls with vacuum applied, the EGR system is okay.
  4. Reconnect solenoid valve connector and apply 3.9 in. Hg of vacuum. If engine performance remains stable (no stall or idle degradation) the negative chamber of the EGR valve is open to atmosphere and EGR is okay. If unstable idle occurs, the solenoid valve is staying closed (inoperative) and must be replaced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.