1985 Mitsubishi GalantFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor

  1. Turn ignition switch to "OFF" position. Disconnect sensor connector. Check resistance across poles "1" and "3". Total resistance should read 4000-6000 ohms.
  2. Connect a circuit tester across poles "1" and "2" or across poles "2" and "3". Check to ensure that when throttle valve is slowly operated from idle to fully opened position, resistance changes smoothly.
INTAKE AIR TEMPERATURE SENSOR "B" RESISTANCE

Temperature Β°F (Β°C) Resistance (Ohms)
68 (20) 2450
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.