1985 Mitsubishi GalantFACTORY OEM SERVICE PROCEDURE

ISC Servo

  1. Connect voltmeter between terminal "3" and injection mixer body. Do not disconnect ISC servo connector. Turn ignition switch to "OFF" position then to "ON" position. While keeping ignition on for at least 15 seconds, check voltmeter reading.
  2. If voltmeter needle reads 11V-13V with ignition switch on after momentary indication of 1V, needle indicates 6V-13V, ISC servo and position switch are operating normally. Turn ignition switch to "OFF" to remove voltmeter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.