1985 Mitsubishi GalantFACTORY OEM SERVICE PROCEDURE

Control Relay

  1. Control relay is mounted on top of ECU. Disconnect electrical harness and test continuity between terminals "1" and "7", then "3" and "7". If there is no continuity, relay is good. If continuity is measured, replace control relay.
  2. Apply 12 volts across terminals "8" (positive) and "4" (negative) while testing continuity between terminals "3" and "7". If continuity is measured, relay is good. If not, replace relay.
  3. Apply 12 volts across terminals "6" (positive) and "4" (negative) while testing continuity between terminals "1" and "7". If there is continuity, relay is good. If not, replace relay.
  4. Apply 12 volts across terminals "5" (positive) and "2" (negative) while testing continuity between terminals "1" and "7". If there is continuity, relay is good. If not, replace relay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.