1983 Mitsubishi Starion BaseFACTORY OEM SERVICE PROCEDURE

Throttle Position Sensor

  1. Disconnect electrical connector from sensor. Connect ohmmeter leads between terminals 1 and 3. When throttle valve is slowly operated from idle to wide open throttle, resistance value should change smoothly.
  2. Total resistance measured at terminals 1 and 3 of sensor should be 4000-6000 ohms. If not, replace sensor and repeat ECI check.
Fig 1: Measuring Throttle Position Sensor Resistance Make sure leads are properly connected.
G42093
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.