1983 Mitsubishi Starion BaseFACTORY OEM SERVICE PROCEDURE

EGR Control Solenoid Valve

  1. Start engine and run at idle until normal operating temperature is obtained. Disconnect Green stripe hose from fuel injection mixer and connect vacuum pump to hose.
  2. Disconnect electrical connector from solenoid valve and apply 9.8 in. Hg to Green stripe hose. If idle becomes unstable or engine stalls, EGR system is operating properly.
  3. Reconnect electrical connector and repeat step 2). Engine idle should not be affected. If idle becomes unstable or engine stalls, solenoid valve is remaining closed. Replace solenoid valve.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.