Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Idle Speed Control (ISC)
The Idle Speed Control (ISC) system increases engine idle speed when A/C compressor is operated, without changing throttle valve position. The system consists of a solenoid valve, air by-pass valve and air by-pass passages in the fuel injection mixer. See Fig 1 .
The ECU energizes the solenoid valve when A/C compressor switch is closed. When energized, the solenoid valve allows the air by-pass valve to open. When by-pass valve opens, additional air is admitted below throttle valve to increase idle speed. This system helps prevent engine stalls due to engine load changes.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
