Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Mitsubishi Starion BaseFACTORY OEM SERVICE PROCEDURE
Idle Speed Control System
- To adjust idle speed control system, start engine and allow to idle until coolant temperature reaches 185-205Β°F (85-96Β°C). Turn all lights and accessories off and place transmission in neutral. Electric cooling fan must be off during adjustment.
- Check curb idle speed and adjust if necessary. Turn A/C system on. Adjust engine speed to 1000-1100 RPM by turning adjusting screw on idle speed control system solenoid valve. See Figure .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
