Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Functional description
The terminating resistor for the corresponding CAN bus is installed in the CAN terminator. In addition, a tap to ground with a resistor and a capacitator is installed to reduce high-frequency faults.
Ferrites are installed in the CAN terminator for all bus connections. Ferrites suppress high-frequency faults in the CAN data lines. This makes line lengths of up to 5 metres possible in the wiring harness.
The following graphic shows the CAN terminator using the example of the F45.
| Item | Explanation |
|---|---|
| 1 | 26 pin plug connection |
| 2 | CAN terminator K-CAN2 |
| 3 | CAN terminator K-CAN3 |
| 4 | 26 pin plug connection |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
