Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Collision warning
In contrast to the collision warning, with Active Cruise Control (ACC = Radar), a camera-based technology is applied. Beyond a speed threshold of 15 km/h, the collision warning can issue warnings to rear views of vehicles.
The collision warning has the following subfunctions:
- Initial warning
Warning, e.g. for signs of collision risk or for very small distances to a vehicle ahead.
Warning through red vehicle symbol in the instrument cluster, alternative Head-Up Display.
- Static prewarning for small distance
- Dynamic prewarning for approaching
- Acute warning
Warning for immediate risk of collision, if the vehicle approaches another object with relatively high differential speed.
Flashing red vehicle symbol in the instrument cluster, alternative Head-Up Display and acoustic warning signal
- Pre-filling of the brake
- Adaptation of the thresholds for the Dynamic Brake Control
A Check Control message is also issued.
The time of the warning can be dependent on different values. For example:
- Classification of the current driving situation
- Possibly wet roadway
- Estimation of the attention of the driver via pedal movements and steering wheel movements
Observe functional limitations in the Owner's Handbook !
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
