2017 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Functional description

The following functions are controlled by the Body Domain Controller (BDC).

  • Terminal control
  • Electronic immobiliser and control of drive authorization
  • Central locking system with control of the access authorization and locking authorization
  • Comfort Access and contactless tailgate opening
  • Steering column switch cluster with electrical steering column adjustment
  • Front and rear exterior lights and brake light
  • Interior lighting
  • Power window regulator, front and rear
  • Exterior mirror including mirror heating
  • Inside mirror and rain-light-solar-condensation sensor
  • Wash/wipe system with washer jet heating and rear wiper
  • Seat heating (if no seat module is present)
  • Automatic air recirculation control
  • Rain-light-solar-condensation sensor
  • Reading the fuel tank level

The central gateway module (ZGM) is integrated into the Body Domain Controller (BDC). It is seen as a control unit within the control unit, as the central gateway module (ZGM) acts as a self-sufficient control unit within the Body Domain Controller (BDC).

The task of the central gateway module (ZGM) is to connect all bus systems. This combination allows general use of information from the individual bus systems. The central gateway module (ZGM) is able to implement various reports and speeds on other bus systems. The programming data are transferred to the vehicle by Ethernet via the central gateway module (ZGM).

G09872256Courtesy of BMW OF NORTH AMERICA, INC.
Item Explanation
1 Body Domain Controller (BDC)
2 54 pin plug connection
3 54 pin plug connection
4 54 pin plug connection
5 54 pin plug connection
6 12 pin plug connection
7 54 pin plug connection
8 42 pin plug connection
9 Right fuse
10 1-pin plug connection
11 Left fuse
12 54 pin plug connection
13 42 pin plug connection
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.