2017 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Adjustment, Consumption Calculation: Application

NOTE: if the adjustment is used, there must be no faults in the DDE control unit or other faults in engine operation.

Adjustment can be used if the customer determines and complains about a deviation between the following values:

  • Fuel consumption calculated by the on-board computer
  • Fuel consumption determined on the basis of refuelling

These two values must be entered at the corresponding point during the adjustment procedure. The adjustment function then automatically calculates the correct correction factor and transfers it to the DDE control unit.

The correction factor can decrease or increase by a maximum of 10 %. If the newly calculated correction factor is outside these limits, the user will be given the option of setting the factor to the maximum permissible limit or not at all.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.