2017 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Functional Description (F57): Adaptations: Notes

Adaptations enable automatic adaptations of parameters in the engine control unit software. As a result, engine control automatically adapts the component tolerances or adapts the values in the system. The "Reset all adaptation values" service function resets all adaptation values in the engine control unit to their original condition. A replaced teach-in of the values is carried out upon terminal change, engine running, partial load operation or full load operation, depending on the adaptation.

NOTE: Deleting adaptations after repairs:Β 
In general, the adaptations should not be deleted after a repair (part replacement). Observe the notes in the corresponding ABL.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.