2016 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Cell Supervision Circuit: Notes

Attention  !

The electrical voltage of the high-voltage battery unit is significantly greater than 60 volt. Therefore, the following electrical safety rules need to be observed before starting to work on the high-voltage battery unit:

  1. Disconnect from voltage supply
  2. Secure against unintentional restart
  3. Check that no voltage is applied

A cell block is a parts group comprising of multiple battery cells, heat conduction plates with insulating films and temperature sensors, and is monitored by the cell supervision circuit.

One cell module features 12 battery cells. In total there are 8 cell blocks (96 cells).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.