2016 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Functional description

The terminating resistor for the corresponding CAN bus is installed in the CAN terminator. In addition, a tap to ground with a resistor and a capacitator is installed to reduce high-frequency faults.

Ferrites are installed in the CAN terminator for all bus connections. Ferrites suppress high-frequency faults in the CAN data lines. This makes line lengths of up to 5 metres possible in the wiring harness.

The following graphic shows the CAN terminator using the example of the F45.

G11650691Courtesy of BMW OF NORTH AMERICA, INC.
Item Explanation
1 26 pin plug connection
2 CAN terminator K-CAN2
3 CAN terminator K-CAN3
4 26 pin plug connection
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.