2016 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Functional description

The additional brake light (CHMSL) is activated by the footwell module (FRM), the Rear Electronic Module (REM) or the Body Domain Controller (BDC).

A direct wire links the brake light switch to the footwell module (FRM) or the Front Electronic Module (FEM) or the Body Domain Controller (BDC).

The footwell module (FRM) or the Rear Electronic Module (REM) or the Body Domain Controller (BDC) receives the bus signals from the DSC (DSC) through the CAN bus. The bus signals contain information regarding the characteristic of the braking deceleration as well as the regulating operation of the Dynamic Stability Control. The footwell module (FRM) or the Rear Electronic Module (REM) or the Body Domain Controller (BDC) processes these data and then activates the additional brake light once Terminal R is under power.

G11650540Courtesy of BMW OF NORTH AMERICA, INC.

F01 shown

Item Explanation
1 two pin plug connection
2 Housing with light-emitting diode as light source
3 Additional brake light
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.