2016 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Structure and inner electrical connection

The accelerator-pedal module functions with induction. The two sensors receive separate 5-volt power supplies from the engine-management control unit, to which they also have separate earth connections. The electronic processing circuitry generates analogue voltage signals, reflecting the accelerator pedal's position, for use by the engine-management control unit. The sensor signals are transmitted to the engine-management control unit separately.

G09871465Courtesy of BMW OF NORTH AMERICA, INC.
Index Explanation
1 Pedal sensor position
2 Hall-effect sensors
3 Evaluation electronics
PIN ASSIGNMENT SPECIFICATION

Pin Explanation
Terminal 31E Terminal 31, electronics earth for Sensor 1
Terminal 31E Terminal 31, electronics earth for Sensor 2
5 V 5-volt power supply for Sensor 2
SIG1 Sensor 1 sensor wire
5 V 5-volt power supply for Sensor 1
SIG 2 Sensor 2 sensor wire
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.