2014 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Wheel-slip control system

WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.

The wheel-slip control system is essentially maintenance-free; however the following must be observed:

  • When carrying out welding work with electric welding equipment, be sure to disconnect the plug from the electronic control unit (ignition turned off).
  • During painting work, the control unit may be subjected for brief periods to loads of max. 95Β°C and for long periods (approx. 2 hours) to loads of max. 85Β°C.
  • Terminals must be completely tight on end poles of battery.
  • Brake lines on hydraulic unit must not be swapped over: if applicable, mark them prior to disassembly.

    On completion of repair work, carry out swap-over test with the DIS diagnosis system.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.