2012 Mini Cooper Clubman, Automatic TransFACTORY OEM SERVICE PROCEDURE

61 00... Encode/program control unit(s)

NOTE: Depending on the vehicle and the equipment, the following flat rate unit items are available for programming/encoding:
  • 61 00 710
  • 61 00 720
  • 61 00 730
NOTE:
  • In order to avoid incorrect programming procedures and fault messages, it is essential when working with the ISTA/P programming system always to use the version.
  • Battery voltage must not drop below 13.0 V  during programming.

Only use chargers recommended by BMW for low voltage vehicle electrical system.

Attention. 

No high-voltage switch off is required in electric vehicles or hybrid vehicles for programming/encoding. 

The high-voltage system will be automatically switched off by the programming system.

programming routine via ISTA/P  :

  • Connect the battery charger to the vehicle.
  • Connect the programming system with the vehicle.
  • Determine the action plan.
  • Accept action plan with the control units to be programmed/encoded and enabled, if necessary or work through.
  • Observe the reworking list.
  • If applicable, connect the workshop system to the vehicle depending on the rework list, run the brief test and delete the fault memory.
    NOTE: A switch to the workshop system may not necessarily be required with the integration of the service functions and the "Delete fault memory" function in ISTA/P. Check the rework list accordingly.
  • The applicable service information for programming the workshop system and the user documentation/instructions must be observed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.