2012 Mini Cooper Base, 2D Hatchback, Standard TransFACTORY OEM SERVICE PROCEDURE

11 61 Intake plenum

TIGHTENING TORQUE SPECIFICATIONS - INTAKE PLENUM

  Type Thread Tightening specifications Dimension
1 Intake manifold to AZ cylinder head N18 M8 x 125   15 Nm
  N18 AM7 Hexagon nut 20 Nm
2 AZ Holder to crankcase N18 M8   20 Nm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.