Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mini Cooper Base, 2D Hatchback, Automatic TransFACTORY OEM SERVICE PROCEDURE
Rear (E53)
WARNING: This page does not describe the selected car, but rather 127 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Unscrew a stubborn nut with special tool (32 3 152).
- Release nut (1) with special tool (32 3 151/152) and remove. See Fig 1.
- Replace nut (1). Eccentric washer (2) must be located between stops. See Figure.
- Tighten down new nut (1) with special tool (32 3 151/152) to specification. See E53Β under TORQUE SPECIFICATIONS.
- Slacken nut (1) approximately 3/4 turn.
- Adjust toe-in by turning eccentric screw. See Figure. Tighten to specification. See E53Β under WHEEL ALIGNMENT SPECIFICATIONS.
- Tighten down nut with special tool (32 3 151/152) to specification. See E53Β under TORQUE SPECIFICATIONS.
CAUTION:
If the nut is tightened down more than 4 times during adjustment, it must be replaced again. The self-locking effect becomes too slight.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
