Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Section 695 (Engine Electrical System - Repair)
WARNING: This page is about a different car, the 2003 BMW 525i, 2002 BMW 525i, 2001 BMW 525i, and 2000 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.
- Troubleshooting
- Ignition Wires, Spark Plugs
- Ignition Coil
- 12 13 Notes on checking ignition system
- 12 13... Checking secondary signal for stationary ignition distribution
- 12 13... Normal oscillogram (M, S, W engines only)
- 12 13 009 Checking rod-type ignition coils (M54, M56, N40, N42, N45, N46, N52, N62, N73)
- 12 13 511 Replacing ignition coil (M52, M52TU, S52, S50US, M54)
- 12 13 520 Replacing a spark plug connector (M60, M62, M54)
- Electronic Switching
- 12 14 521 Replacing pulse generator on crankshaft (M54/M56)
- 12 14 523 Replacing pulse generator on inlet camshaft (M52TU / M54 / M56)
- 12 14 524 Replacing pulse generator on exhaust camshaft (M52TU, M54, M56)
- 12 14 550 Replacing control unit (DME) (M52, M62, M54)
- 12 14 600 Replacing knock sensor (M52TU, M54, M56)
- 12 14 700 Coding control module (DME / DDE)
- 12 14 705 Programming control unit (DME / DDE)
- 12 63 520 Replacing main relay (S62, M54)
- 61 35... Note on replacing codable/programmable control units
- Alternator With Device
- Regulator
- Starter With Mounting
- Starter Lead
- Engine Wiring 100M
- Pressure Oil Temperature
- 12 61 250 Removing and installing/replacing oil temperature switch (M52TU, M54, M56)
- 12 61 280 Removing and installing/replacing oil pressure switch (M52TU, M54, M56)
- 12 61 285 Replacing level switch for engine oil
- 12 61 285 Replacing level switch for engine oil (Z3 M54)
- 12 61 285 Replacing oil level sensor
- Switches and Relays
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
