Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Hydraulic Unit
To control braking system pressure, brake hydraulic unit has a 3-way valve which permits 3 separate brake pressure conditions. Pressure build-up, pressure retention and pressure drop are the 3 pressure phases that adapt to vehicle braking requirements. Control procedures are as follows:
- As soon as wheel lock-up is indicated, brake fluid pressure is reduced. If wheel still tends to lock, pressure will be further reduced until wheel acceleration or slip limit is detected. Pressure is then raised and the control phases repeated. These pressure changes occur in milliseconds.
- The return delivery pump returns brake fluid from wheel brake cylinder, while dropping pressure to appropriate brake circuit. The pump is a 2-piston pump design so circuits of a dual brake circuit system remain separated.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
