2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

31 00... Notes on repairing threads: Procedure

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Create a clean core hole; if necessary, drill out screw remnants
    Fig 1: Drilling Clean Hole Core For Helicoil Thread Insert
    G08527587Courtesy of BMW OF NORTH AMERICA, INC.
  2. Create locating thread for Helicoil thread insert
    Fig 2: Creating Locating Thread For Helicoil Thread Insert
    G08527588Courtesy of BMW OF NORTH AMERICA, INC.
  3. Pick out Helicoil thread insert in accordance with the TABLE and screw into the locating thread until flush with the original thread
    Fig 3: Inserting Helicoil Thread Into Locating Thread
    G08527589Courtesy of BMW OF NORTH AMERICA, INC.
  4. Break drive pin and remove
    Fig 4: Removing Drive Pin
    G08527590Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.