2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Section 233 (Electrical Component Locator): Splices

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1998 BMW 750iL, 1998 BMW 740iL, 1998 BMW 740i, 1997 BMW 750iL, and 1997 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.
SPLICES LOCATION

Component Location
X181 Below glove box. See Figure.
X188 Below glove box. See Figure.
X197 Below glove box. See Figure.
X217 Below left side of dash. See Figure.
X218 Rear center console. See Figure.
X265 Left rear sill. See Figure.
X596 Below glove box. See Figure.
X704 Rear center console. See Figure.
X1461 Left side of dash. See Figure.
X1493 Left side of dash. See Figure.
X6438 Right rear of engine compartment. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.