Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Section 1915 (Transfer Case - Repair)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer Case, General
- 10 Transfer Case
- 27 10... Checking Function Of Front Differential And Transfer Case
- 27 10 010 Removing And Installing Transfer Case (ATC 300)
- 27 10 020 Installing Replacement Transfer Case (ATC 300)
- 27 10 050 Replacing Output Flange For Front Axle Output (ATC 300)
- 27 10 070 Replacing Output Flange On Transfer Case At Rear (ATC300)
- 27 10 700 Removing And Installing/Replacing Control Unit For Transfer Box (ATC 300)
- 27 10 710 Replacing Classification Resistor For Servomotor (ATC 300)
- 27 10 720 Replacing Servomotor (ATC 300)
- 21 Transmission Shafts
- 27 10 070 Replacing Output Flange On Transfer Case At Rear (ATC300)
- 27 21 010 Replacing Radial Shaft Seal For Drive Flange (ATC 300)
- 27 21 020 Replacing Radial Shaft Seal For Output Flange (ATC 300)
- 27 21 020 Replacing Radial Shaft Seal For Output Flange, Automatic (ATC 300)
- 27 21 030 Replacing Radial Shaft Seal For Front Axle Output (ATC 300)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
