Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

86 10 ... Replacing Bar

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Disassembly of lashing eyes, refer to 86 10 ... REPLACING LASHING PLATE AND LASHING EYE .

Remove lashing eyes (1).

Fig 1: Identifying Lashing Eyes

G04786728

Courtesy of BMW OF NORTH AMERICA, INC.

Remove protective caps (1) on left/right.

Fig 2: Identifying Protective Caps

G04766420

Courtesy of BMW OF NORTH AMERICA, INC.

Release hexagon screws (1) and countersunk head screws (2) on left/right.

Remove bar.

Installation:

Tighten hexagon screw.

Tighten countersunk head screw.

Tightening Torque. Refer to TRAILERS - TIGHTENING TORQUES - ALPINA .

Fig 3: Identifying Countersunk Head Screws

G04766421

Courtesy of BMW OF NORTH AMERICA, INC.

Chapter Navigation

Return to Chapter: 10 Loading Platform

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.