2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

86 10 ... Disassembly Of Rear Apron

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Remove rear light, refer to 86 10 ... REPLACING REAR LIGHTΒ .
Remove plastic bush/metal bush. Refer to 86 10 ... REMOVING PLASTIC BUSH/METAL BUSHΒ .

Cut through sealing compound (1) on left and right and remove.

Drill out rivets (2) on left and right sides on lower apron edge.

Installation:Β 

Use Sikaflex 221 as sealing compound.

Fig 1: Identifying Rivets On Left And Right Sides On Lower Apron Edge
G04786651Courtesy of BMW OF NORTH AMERICA, INC.

Cut through sealing compound (1) and remove.

Drill out rivets (2).

Installation:Β 

Use Sikaflex 221 as sealing compound.

Fig 2: Identifying Sealing Compound And Rivets
G04786652Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.