2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Toe-In Adjustment

WARNING: This page is about a different car, the 2004 BMW 545i, 2004 BMW 530i, and 2004 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The camber must be adjusted first. See CAMBER ADJUSTMENTΒ  .

If necessary, remove steering wheel cover. Slacken clamping nut (2), gripping tie rod end (1) in the process. Remove clamp (4). Turn tie rod (3) to adjust toe-in to specified value. See Fig 1 . See WHEEL ALIGNMENT SPECIFICATIONSΒ  . Install clamp (4).

Fig 1: Adjusting Toe-In
G00316912Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.