Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

86 10 ... Replacing Gaiter

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Position brake lever fully towards rear.

Release screws (1) and (2) and remove. Pull off towing attachment (3) in direction of arrow.

Installation:

Tightening Torque: 86 10 15AZ, see 86 10 PLATFORM .

Fig 1: Identifying Screws & Towing Attachment

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off gaiter (1) in direction of arrow.

Fig 2: Identifying Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Chapter Navigation

Return to Chapter: 10 Loading Platform

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.