Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mini Cooper Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW X5, 2005 BMW X5, 2004 BMW X5, 2003 BMW X5, and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Reinforcement Plate-To-Front Axle Support/Engine Carrier | 41 (56) | |
| Starter Motor-To-Transmission Bell Housing | ||
| Step 1 | 33 (45) | |
| Step 2 | Additional 90 degrees | |
| Step 3 | Additional 15 degrees | |
| INCH Lbs. (N.m) | ||
| Electrical Leads-To-Starter | ||
| 5 mm | 44 (5) | |
| 6 mm | 62 (7) | |
| 8 mm | 115 (13) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.