Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Mini Cooper Works ClubmanFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Accelerator Pedal Module (B10) | Part of acceleration pedal assembly. See Figure. |
| Amplifier (A18) | Under driver's seat. See Figure. |
| Car Access System (A149a) | Left top side of dash. See Figure. |
| Comfort Access Control Module (A215) | Behind right rear trim panel. See Figure. |
| Convertible Top Module (A96b) | Left side of convertible top compartment. See Figure. |
| DME Control Unit (A6000) | Left side of engine compartment. See Figure. |
| Dynamic Stability Control (DSC) (A65a) | Left rear of engine compartment. See Figure. |
| Electromechanical Power Steering (A60233a) | Rear of engine compartment. See Figure. |
| Footwell Module (A4011) | Left side of left footwell. See Figure. |
| Fuel Tank Leakage Diagnostic Module (M119a) | Front of right rear wheel. See Figure. |
| Interior Movement Detector (A121b) | In overhead console. See Figure. |
| Multiple Restraint System Control Unit (A12) | Center console. See Figure. |
| Outside Mirror Fold-In (A208) | Behind left rear trim panel. See Figure. |
| Park Distance Control Unit (PDC) (A81) | Right side of rear compartment. See Figure. |
| Sunroof Module Control Unit (A33) | Under center front headliner. See Figure. |
| Tire Pressure Control (RDC) (A85a) | Right side of luggage compartment. See Figure. |
| Transmission Management (A7000a) | Under left side of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.