2008 Mini Cooper S, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Diagnostic Head

The DISplus uses a Diagnostic Head similar to the DISplus III as the communication link between the DISplus and the vehicle electronics.

The Head receives operating power when the diagnosis cable is connected to the vehicle.

Fig 1: DISplus Diagnostic Head
G04729967Courtesy of BMW OF NORTH AMERICA, INC.

Communication between the DISplus and the Head can occur two ways:

  • Radio frequency (maximum 30m distance)
  • Hard wired to the network or DISplus
Fig 2: Communication Between DISPlus And Head
G04729968Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.