2007 Mini Cooper Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

Check Control Messages (M62 01 07)

Publication date: 2007-03-14
Reference number: M62 01 07

CHECK CONTROL MESSAGES

CHECK CONTROL MESSAGES

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M62 01 07, Date of Issue:  March 14, 2007
MINI: R56 (Cooper, Cooper S)
GROUP: Instruments

SUBJECT

Check Control Messages 

INFORMATION

In situations where the customer complains of a check control (CC) message, but the message is currently not displayed, the last (72) CC messages are stored in the instrument cluster and can be viewed using DIS V49.0, or later. (Note: Only important messages are stored. Messages concerning e.g. door open, are not stored.)

To view stored CC messages, from the Diagnosis Operation and Component Selection screen, select "Service Functions/Vehicle Information/Check Control Messages/Test Plan"  . Follow the on-screen prompts to run the test plan. Each stored CC message can be displayed together with its identification number and the vehicle mileage when it was stored.

The attachment lists all possible CC messages with a description of each.

WARRANTY INFORMATION

Information only.

ATTACHMENTS

Fig 1: Instrument Cluster Diagnosis/Check-Control Messages (Page 1)
G05745633
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.