Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mini Cooper Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 1210 (Front Axle - Repair)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
- 00 General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 00 ... ... Raising vehicle with trolley jack
- 31 ... . Front axle overview
- 31 .. .. Layout of spring strut shock absorber
- 31 00 ... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31 00 ... Information on replacing shock absorbers
- 31 00 ... Instructions (chassis components made of aluminum)
- 31 00 ... Instructions (damage to suspension)
- 31 00 ... Notes on repairing threads
- 10 front axle suspension
- 11 front sub-frame
- 12 struts with rubber mounts
- 21 wheel bearings and stub axle
- 31 spring strut
- 31 .. .. Layout of spring strut shock absorber
- 31 00 ... Information on replacing shock absorbers
- 31 31 000 Removing and installing complete left or right spring strut shock absorber
- 31 31 031 Replacing front left or right spring strut shock absorber
- 51 71 373 Removing and installing/replacing tension strut on spring strut dome
- 33 spring with suspension
- 35 stabilizer bar
- 31 35 000 Removing and installing/replacing front stabilizer
- 31 35 005 Removing and installing/replacing push rod (stabilizer link) for left/right stabilizer
- 31 35 007 Removing and installing/replacing holder for left or right push rod/stabilizer
- 31 35 021 Replacing rubber mounts of stabilizer retaining fixture on front axle carrier
- 90 troubleshooting
- Special Tools
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.