Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mini Cooper Base, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine - Repair - Cooper (N12 Engine)
- 00 Engine, General
- 00 Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
- 00 Risk Of Injury If Oil Comes Into Contact With Eyes And Skin
- 00 Safety Information For Working On Vehicles With Automatic Engine Start-Stop System (MSA)
- 00 Safety Instructions For Handling Oil
- 11 00 Removing And Installing/Replacing Acoustic Cover (N12)
- 11 00 050 Removing And Installing Engine With Transmission (N12)
- 11 00 670 Securing Engine In Installation Position (N12, N14)
- Engine Identification
- Mounting Engine On Assembly Stand (N12)
- 12 Cylinder Head With Cover
- 13 Oil Sump
- 14 Housing Cover
- 21 Crankshaft With Bearing
- 22 Flywheel
- 23 Vibration Damper
- 24 Connecting Rod With Bearing
- 25 Piston With Rings And
- 28 V-Ribbed Belt With TENSIONER
- 31 Camshaft
- 11 31 005 Checking Camshaft Timing
- 11 31 025 Removing And Installing/Replacing Inlet Camshaft (N12)
- 11 31 028 Removing And Installing/Replacing Exhaust Camshaft (N12)
- 11 31 051 Replacing Timing Chain (N14)
- 11 31 090 Installing And Removing/Replacing Chain TENSIONER Piston (N12)
- 11 31 505 Adjusting Camshaft Timing (N12)
- 33 Rocker Arm With Bearing
- 34 Valves With Springs
- 36 Variable Camshaft Timing
- 37 Variable Valve Gear
- 40 Oil Supply
- 41 Oil Pump With Filter A
- 42 Oil Filter And Lines
- 43 Oil Filling, Dipstick
- 51 Water Pump With Drive
- 53 Thermostat And Connect
- 61 Intake Manifold
- 62 Exhaust Manifold
- 66 Vacuum Pump
- 78 Emission Control, Oxygen
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.