Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mini Cooper Base, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator (Convertibles): Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Back-Up Light Switch (S8511) | Top Left of transmission. See Figure. |
| Brake Fluid Level Switch (B18) (1.6L) | Left side of engine compartment. See Figure. |
| Brake Fluid Level Switch (B18) (1.6L Supercharged) | Left side of engine compartment. See Figure. |
| Brake Light Switch (S29) | Left side of left footwell. See Figure. |
| Clutch Switch Module (S805) | Left side of left footwell. See Figure. |
| Gearshift Lock (S235) | Center console. See Figure. |
| Ignition Switch (S2) | Behind left side of steering wheel. See Figure. |
| Inertia Switch (I01149) | Left side of engine compartment. See Figure. |
| Microswitch (I11385) | Rear parcel shelf. See Figure. |
| Microswitch (I11386) | Rear parcel shelf. See Figure. |
| Microswitch (I13073) | Top left side of trunk. See Figure. |
| Microswitch (I13076) | Top right side of trunk. See Figure. |
| Oil Pressure Switch (B6231) (1.6L) | Right front of engine. See Figure. |
| Oil Pressure Switch (B6231) (1.6L Supercharged) | Right front side of engine. See Figure. |
| Switch, Trunk Lid Contact (S213) | Left rear of trunk. See Figure. |
| Underhood Light Switch (S19) | Right front side of engine compartment. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
