Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2006COOPER CONVERTIBLE (R52) L4-1.6L (W10)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTUNE-UP AND ENGINE PERFORMANCE CHECKSCOMPRESSION CHECKTESTING AND INSPECTION
2006 Mini Cooper Convertible (R52) L4-1.6L (W10)
Compression Check: Testing and Inspection
2006 Mini Cooper Convertible (R52) L4-1.6L (W10)SECTION Testing and Inspection
11 00 039 - Checking compression at all cylinders
Special tools required:
- 11 0 224 11 0 220 Compression Test Kit
- 11 8 490 11 8 490 Test Probe
Note:
Read out fault memory of EMS/DME control unit, check stored fault messages, rectify faults and clear fault memory.
Switch off ignition.
Caution!
High tension - danger!
Interrupt voltage supply to ignition coils.
Detach plug connector from ignition coil unit.
Press securing clip (1) away.
Detach plug connector (2).
Unscrew all spark plugs Service and Repair.
Screw special tool 11 8 490 11 8 490 Test Probe into spark plug thread and connect special tool 11 0 224 11 0 220 Compression Test Kit.
Make sure seal of adapter tool is in proper working order.
Press accelerator pedal to floor and actuate starter motor until compression pressure stops rising.
Compression pressure.
Refer to Technical Data Engine in General W10 / COOPER / B16.
Note:
Disconnect ignition unit; this results in a defect trouble code being output during starting.
Connect DIS and delete stored faults.
Note:
Read out fault memory of EMS/DME control unit, check stored fault messages, rectify faults and clear fault memory.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.