Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Arming with a Contact Open
If the DWA is armed with the passenger door, tailgate or bonnet open the BC1 will not flash the LED in the relevant mode for the first 10-seconds after arming - this is to indicate to the owner a contact is not closed - after this the LED will flash in confidence mode. The BC1 will also not activate the interior protection and tilt sensor. If the contact is closed after the DWA is armed the LED will flash for 10-seconds in the relevant mode.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.