Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Steering Column Mounting Bracket Bolts | 13-16 (18-22) |
| Steering Coupling Clamp Bolt | 18-22 (24-30) |
| Steering Gear-To-Crossmember Bolts | 11 (15) |
| Steering Wheel-To-Column Shaft | 33-40 (45-54) |
| Tie Rod-To-Front Spindle Nut | 15-23 (20-31) |
| "U" Joint Clamp Bolt | 14-19 (19-26) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.