Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
Turbocharger Systems Check
CAUTION:
If the turbocharger overboost buzzer is activated during testing, throttle must be returned to idle immediately.
- To test turbocharging system, install a pressure gauge in the hose between the EGR solenoid and vacuum tree on the right of power brake booster. The pressure gauge hose must be long enough to reach into the passenger compartment.
- Prepare for road test. Vehicle must be accelerated from 0 to 45 MPH. Observe gauge while accelerating. Turbocharger boost for models with automatic transmission is 13 psi (.9 kg/cm2 ) and 15 psi (1 kg/cm2 ) with manual transmission.
- If pressure reading are not to specification or system performance is inadequate, proceed to individual component testing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
