1987 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

OVERBOOST Warning Switch

  1. Attach jumper wire between overboost warning switch and ground. If buzzer sounds, unit is functional, proceed to step 2).
  2. Remove overboost switch at the buzzer. Use an ohmmeter to verify continuity between buzzer connector (Brown/Yellow) and switch connection.
  3. Verify continuity between switch bracket and ground. If no continuity exists, disassemble and clean surface between bracket and body. Retest to confirm continuity.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.