1987 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

Boost Control Solenoid

  1. Visually inspect wiring and hoses for deterioration or leaks. Ensure that all connections are clean and tight.
  2. Remove solenoid wire connector and turn ignition to the "RUN" position. Attach test light between Red wire of wire connector and ground. If light does not illuminate, an open circuit exists in the power feed circuit.
  3. Attach a jumper wire from solenoid connector purple wire to ground. Turn ignition on and confirm that solenoid "clicks". If unit does not "click", replace the boost control solenoid.
  4. Attach ohmmeter probes between solenoid connector Purple wire and ECA pin No. 32. If continuity does not exist, repair open in ECA control circuit.
  5. Use a hand operated pump to apply vacuum through the turbocharger hose. Replace unit if vacuum is not held.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.