Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | ||||
|---|---|---|---|---|---|
| Front | |||||
| Camber in Degrees | |||||
| Fraction | (1) | ||||
| Decimal | (1) | ||||
| Caster in Degrees | |||||
| Fraction | (1) | ||||
| Decimal | (1) | ||||
| Toe-In in Inches | |||||
| Fraction | 5/64 +/- 1/32 | ||||
| Decimal | .08 +/- .03 | ||||
| Toe-In in Degrees | |||||
| Fraction | .16 +/- .063 | ||||
| Decimal | (1) | ||||
| Toe-Out in Turns | |||||
| Inner | (1) | ||||
| Outer | (1) | ||||
| Steering Axis Inclination (SAI) | (1) | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
