Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE

Repair and Diagnosis: Electrical: Starter: Specifications

MOTORCRAFT STARTER SPECIFICATIONS

Application		Specification
Load Test Current Draw		150-250 Amps
No-Load Test Current Draw		80 Amps
Brush Length
Original		.45" (11.4 mm)
Maximum Wear Length		.25" (6.4 mm)
Brush Spring Tension		80 oz. (2268 g)
Through Bolt Tightening Torque		45-85 INCH lbs. (5.0-9.6 N.m)

Chapter Navigation

Return to Chapter: Starter

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.