Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Merkur XR4Ti AutomaticFACTORY OEM SERVICE PROCEDURE
Miscellaneous Components
MISCELLANEOUS COMPONENTS LOCATION
| Component | Location |
|---|---|
| Airflow Meter | In engine bay on right front side. See Figure. |
| Fuse/Relay Block | In engine bay in left rear corner. See Figure. |
| Heat Seat Resistor | Behind lower center of instrument panel, near console. |
| High Pressure Fuel Pump | Underneath vehicle, in front of fuel tank. |
| Ignition Coil | Mounted on inner fenderwell, below shock tower. See Figure. |
| Low Pressure Fuel Pump | Inside fuel tank. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.